This weekend, we finally got ourselves out of the suck and threw our first board in the press. At the moment, it's sitting in room F6 of the Cubberley Community Center being pressed. This weekend we are going to remove the board from the press, cut it out, and begin to sand it and begin other finishing procedures. We will also be pressing a second board while we sand and finish the first board. We are still looking into finding an artist or some method to design the bottom of our board. Hopefully the press was able to apply enough force to the board so that the board was able to contour perfectly to the press. After we finish the board, we will be placing some of my spare parts on the board so that I can go test ride it in Stanford. Below is a picture of our press:
No comments:
Post a Comment